Hi Joe
First rotator (rotor?) I had here was a right angle gear and mast outside
the shack with a steering wheel inside to turn the antenna. Even had a
directional indicator :-) 73
Tom W7WHY
> OK I'm busted...
> My budget is going to be very tight for a while after I move to the new
> qth. I kinda put my foot down with the wife so that I can get the funds
> for
> the tower but there is not much left over after that (unless the home I am
> in now sells for a bit more than I think it will)
> Most of you might know where I am going with this by now...
>
> For a while I can see me turning the beams by hand. That should not be a
> problem (just a pain in !$$) as the tower will be right next to my shack.
> I could keep that set up and build a chain or gear driven rotor myself and
> add it later. I know its better just to buy one but like most hams, I like
> building stuff.
> Joe
> KI4ILB
>
>
>> Maybe I"m overlooking something but, where does the rotor go once you
>> have the mast sitting on a steel ball in the base of the tower?
>>
>> Mike / W8DN
>>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|