I would get the US tower.
If you do, you can drive to their Kansas location and pick it up yourself.
This will save a lot of time and money and probably easier to get service
later.
Call this guy for more info.
Ken Millman, K1ZKM
Amateur/Commercial Division
Direct Line: (530) 333-0440
Direct Fax: (530) 333-0390
US Tower Corporation
1099 West ropes Avenue
Woodlake, CA 93286
Phone: (559) 564-6000
Fax: (559) 564-6011
Regards
Dave Harmon
K6XYZ[at]sbcglobal[dot]net
Sperry, Ok.
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of richard allen
Sent: Saturday, December 09, 2006 8:29 AM
To: towertalk@contesting.com
Subject: [TowerTalk] height fold over kits?
I am trying to decide between a us tower hdx555 with the motor drive
and foldover fixture and/or a heights foldover aluminum tower of
equivalent height.
Either will have a 10-20 foot mast at the top with one large (50')
six meter
yagi and relatively small yagis for 144, 220, 432, and 1296. I need
to be able
to work on the antennas from the ground level as I cannot climb.
Any comparisions or comments would be appreciated. I have read good
and bad about both approaches.
Richard W5SXD
Mineral Wells, Texas
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|