I have rebuilt many Ham 2,3 and 4 rotors. The tail twister is in a
different shell but the guts are about the same . The best way is to turn the
rotor
to the north or center position. it will make it a lot easier to reinstall it.
like the other guy said always mark the from top to bottom where it comes
apart. That way you should be ok when you stick it back together. The best way
to take it apart is to make sure you have it upside down that way the
bearings will remain on the top section of the rotor. With that said have fun
and
grease it up real good and you should have many years of use out of it...
If I can help drop me a line and will be glad to help you out.
Randy
WB4UNA since 1970
Carlus M. Randy Chavis
247 Goff Court
West Columbia
SC 29172
BANDS : SSB,CW
10-160,6,2,432,220
EM93KV
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|