By putting the amplifier at the antenna, too.
Simple solution with a lot of logistics to overcome.
Don
N8DE
Keith Dutson wrote:
>How does that work running a high power amp?
>
>73, Keith NM5G
>
>-----Original Message-----
>From: towertalk-bounces@contesting.com
>[mailto:towertalk-bounces@contesting.com] On Behalf Of Don Havlicek
>Sent: Wednesday, December 20, 2006 3:28 PM
>To: Craig Thompson
>Cc: towertalk@contesting.com
>Subject: Re: [TowerTalk] Radio Frequency Systems Cable
>
>This has been done often in the past:
>
>put a transverter for your particular band AT the antenna and use cheaper
>coax to run to your HF rig.
>
>Don
>N8DE
>
>Craig Thompson wrote:
>
>
>
>>I am considering a low loss coax for VHF and UHF on a 90 foot motorized
>>
>>
>tower. It has to be flexible, high power and low loss. I found a 1 1/4" coax
>by RFS RFS UCF114-50JA. It is not cheap. Has anyone had any experience with
>this cable? I have used LMR600UF but it is too lossy for EME up to 1296. Do
>you have any other suggestions?
>
>
>>Thanks, Craig
>>K9CT
>>
>>
>>
>>
>>
>>_______________________________________________
>>
>>
>>
>>_______________________________________________
>>TowerTalk mailing list
>>TowerTalk@contesting.com
>>http://lists.contesting.com/mailman/listinfo/towertalk
>>
>>
>>
>>
>>
>
>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
>
>
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|