Link comes up as can not be found on my machine.
Julio, W4HY
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of k1vr@juno.com
Sent: Thursday, January 11, 2007 3:20 PM
To: kc8hz@hotmail.com; TowerTalk@contesting.com
Subject: Re: [TowerTalk] Rohn TB3 or TB4
On Thu, 11 Jan 2007 15:08:00 -0500 "Roger Kissel" <kc8hz@hotmail.com>
writes:
> So you're all saying that lubrication should not be used with a Rohn
> thrust bearing ?
<snip>
> For the time being, I have built back the bad races with TIG and am
> going to remachine the grooves and use new balls and see if I can
reuse
the
> bearing. If not, I'll put up a STEEL bearing.
An article by K1IR on repairing a "stuck" Rohn TB-3 thrustbearing was
first posted on TowerTalk, and then printed in NCJ. Here's the link to
the TowerTalk posting:
http://lists.contesting.com/_towertalk/1998-December/021126.html
Fred Hopengarten K1VR hopengarten@post.harvard.edu
Six Willarch Road * Lincoln, MA 01773-5105
781/259-0088; FAX 419/858-2421
www.antennazoning.com _______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|