Getting closer, I think. After following suggested troubleshooting, found
that the pot in rotor unit goes from zero (full left), rotating right, to
400ohms at approximately 225 degrees, then drops immediately to ZERO for the
next
45 degrees... not good... will put a 500 ohm pot across the control unit to
confirm that there is not also a problem in the display unit. Then try
finding the replacement pot for the rotor from Yaesu...
Thanks, Steve
<BR><BR><BR>**************************************<BR> AOL now offers free
email to everyone. Find out more about what's free from AOL at
http://www.aol.com.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|