Hi all
I just got a MFJ 259B and trying to set up some stubs.
On 40, there is a quarter wave stub, shorted on the end.
On 20, there is a stub the same length, only open.
On the 40 meter stub, do I just tune it for a RX=0, then short the end after
I measure it, or short the end and measure it that way?
And on 20, do I short the end, as in a 1/2 wave and measure it that way?
Thanks and 73
Tom W7WHY
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|