Towertalk
[Top] [All Lists]

Re: [TowerTalk] SteppIR cable

To: <towertalk@contesting.com>
Subject: Re: [TowerTalk] SteppIR cable
From: "Perry - K4PWO" <k4pwo@comcast.net>
Date: Sun, 10 Jun 2007 20:48:33 -0500
List-post: <mailto:towertalk@contesting.com>
The longer cable, due to its resistance, would act as a current limiter 
preventing power supply fold-back.

Have you confirmed that the power supply is really shutting down?  The 
description almost sounds like a "slow" stepper problem.  Can't say for sure 
as I don't know what is in the controller "code" but this sounds a lot like 
a PID loop failure that causes the controller to fault.  You may have a 
binding #4 motor that will operate alone but when any other motor is in 
play, and motor 4 can't get the full share of current, its slow response 
causes the fault.

Just an idea as I saw something like this from a company that "outsourced" 
its controllers and wasn't even aware of the "features" programmed into the 
microcontroller.

73 de Perry - K4PWO

----- Original Message ----- 
From: "Ron Todd" <ron@k4wz.com>
To: <towertalk@contesting.com>
Sent: Sunday, June 10, 2007 8:06 PM
Subject: [TowerTalk] SteppIR cable


> Several mentions were made that it was related to the 500 feet of control
> cable, but SteppIR's engineers say the longer cable would actually help
> reduce the load, so cable length has been ruled out.
>
> I dont know how the longer cable would help.
> I would look at the size of the cable. SteppIR makes two size, one for 
> short runs and one for long runs.
>
> GL  K4WZ   Ron
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>