Telrex used a 1/2 wave balun of RG-11 for their antennas.
Carl
KM1H
----- Original Message -----
From: "Joe Barnes" <n4jbk@bellsouth.net>
To: <towertalk@contesting.com>
Sent: Friday, July 06, 2007 12:10 AM
Subject: [TowerTalk] 6 meter 6 element Telrex
>I have 2 of the 6 element Telrex 6 meter beams I want to get up,
> however the coax loop that goes between the sides of the driven elements
> and ground is missing.Does anyone know what type of coax ( impedance)
> was used for this. I am guessing that it is a 1/4 wave, calculated with
> velocity factor, piece of 50 ohm coax ( rg213 etc). Can anyone confirm
> or deny this please? Also I was told to stack these antennas 13-14 feet
> apart, again any info? Thank you, Joe N4JBK
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|