Dick is not built to stand up there! Gotcha Dick! When's the move?
Carl
KM1H
----- Original Message -----
From: <hdmc38@bellsouth.net>
To: "Dick, W1KSZ" <w1ksz@earthlink.net>; "TowerTalk"
<towertalk@contesting.com>
Sent: Saturday, August 25, 2007 10:11 AM
Subject: Re: [TowerTalk] Another ROHN 45 Question
> Good morning Dick
>
> The G-1000SDXA will bolt up to the plate or the 45AG4? top section.
> I run a similar set up that uses the Rohn TB-3 thrust bearing bolted to
> the top section. Another plus is you can stand on the tower top section.
> Hope this helps.
>
> 73 Joe K4XZ
>>
>> From: "Dick, W1KSZ" <w1ksz@earthlink.net>
>> Date: 2007/08/25 Sat AM 08:24:33 EST
>> To: TowerTalk <towertalk@contesting.com>
>> Subject: [TowerTalk] Another ROHN 45 Question
>>
>> Will the AS455G Accessory shelf accommodate the YAESU
>> G-1000 Rotator without additional drilling ?
>>
>> If you must know why I picked the YAESU, it's because
>> the FT-2000D DMU has that neat rotot control app.
>> --
>> 73, Dick, W1KSZ
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>
> JOE PATRICK
> SENIOR PLUMBING/MECHANICAL
> INSPECTOR CITY OF BOYNTON BEACH
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|