Hello all...I finally got my K9AY receiving array up in the air! Earlier this
spring, I ordered the boards for the switching/bandpass/preamp unit from Far
Circuits. I mounted both the switching board and the bandpass/preamp board out
at the antenna. I noticed something rather strange when I was running some
tests this last weekend and noticed that the preamp is basically useless. I am
able to switch the preamp in and out from my controller.....The problem - when
I switch the preamp on, I start to hear this crackling noise after about 3
secs. I don't notice any change in signal level. Has anyone else had this
problem?
Pictures of my controller are at the link below.
http://www.flickr.com/photos/canoeingriverrat/sets/72157594573973890/
Thanks,
Dave
KB8NNU
____________________________________________________________________________________
Pinpoint customers who are looking for what you sell.
http://searchmarketing.yahoo.com/
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|