All you need to do us connect the guy grips and tumbles on one end then the
other side. Thumble to Thumble. Contact texastowers.com for parts.
73's Bill
On 10/24/07, bob finger <finger@goeaston.net> wrote:
>
> Jim: Just open the larger thimble a bit and put the smaller thimble
> inside. Then use big grips on both Phyllistran and the EHS as usual.
> Works fine. If you don't want to do that a single shackle does the
> job. I have done both and when I need to get the two together out in
> the field I use a 1/2 inch shackle. When I can put them together in the
> shop where a vise is handy I do the thimble inside thimble trick. Be
> sure to use galvanized shackles or you will regret it later. 73 bob de
> w9ge
>
> KC4HW wrote:
>
> >Been looking for a good way to interconnect the 6700 Phillystran portion
> and the 1/4 EHS
> >steel leader portion of guys.
> >
> >I have been looking for a double (Or twin) clevis but have not been able
> to find one that would
> >accommodate the thimbles.
> >
> >So do is suggested to interconnect these guy assemblies?
> >
> >Jim/KC4HW
> >http://www.AlabamaContestGroup.org
> >http://www.AlabamaQSOParty.org
> >
> >
> >_______________________________________________
> >
> >
> >
> >_______________________________________________
> >TowerTalk mailing list
> >TowerTalk@contesting.com
> >http://lists.contesting.com/mailman/listinfo/towertalk
> >
> >
> >
> >
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|