Hi Steve,
In part, you stated:
>
> I use it (LMR-400UF) for rotator loops -
>
So can I assume you mean a loop from a hard-line feeder to the beam around a
rotor?
Now, I seem to remember reading that LMR-400 has a limited bend life. In
fact, the LMR-400 I have on a roll is quite stiff. So I opted for Super 8,
similar to the 9913 flex cable for my rotor jumpers from the Heliax to the
beam. I am not trying to be critical of your statement, but did I overlook
something in my research?
Any of you other fellows wish to 'chime in' and add to the knowledge base?
de Eric - VE3GSI
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|