TexasRF@aol.com wrote:
> I am quite concerned about all the aluminum cleaning chat recently. It is
> well known that any of these abrasive cleaners and pads will leave
> micro-scratches in the aluminum surface.
Sure, but all those scratches will rapidly reoxidize. There is an issue
of little particles of iron stay behind.
Due to the skin effect at our high frequencies,
> the rf flow will encounter a maze of conduction channels that not only will
> increase the electrical length of the element, can reverse the electron
> flow,
> creating pattern nulls in some directions.
Whoa there pardner.. lots of stuff in those statements, most of which is
bogus.
1) maze of conduction channels.. possibly, but, as noted above, once the
surface reoxidizes (in a matter of seconds/minutes) it's no different
than any other rough surfaced conductor.
2) Rough surfaces won't increase electrical length. (if you think it
will, propose some physical mechanism by which this might occur)
3) reverse electron flow? A couple issues. it's pretty well known that
current flow isn't electron flow (the electrons move pretty slowly,
compared to the speed of light. I can't conceive of a surface treatment
that would reverse the current (or electron flow) in localized areas.
And if there were localized bits that went backwards, it's not going to
create pattern nulls.
>
> The only approved method of restoring beam antenna appearance and
> performance is replacement of the aluminum tubing.
Indeed, your manufacturer may not approve of scrubbing up those elements
for one reason or another, which might have an effect on warranty
replacements, but I suspect that anyone polishing their antenna is well
out of warranty.
>
> You can find a complete selection of NEW virgin aluminum tubing at great
> prices at _www.texastowers.com_ (http://www.texastowers.com) under the
> heading
> "aluminum". With these low prices and availability, there is no reason to
> even think about any other restoration method. Who wants to be caught
> scrubbing
> aluminum when you could be hamming it up instead?!
I would agree that replacing tubing is preferable, and easier if the
original tubing is really thrashed, however for someone who has some
spare time on their hands and wants to clean up surface crud on an
antenna before selling it, storing it, or just putting it up after it's
been lying out in the weeds, a bit of casual work with a scrubby sponge
isn't a bad thing. The suggestion for liquid electrolyte replacement
while doing the work will make it seem to go faster. If you're looking
for that optical mirror polish, well...
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|