One way rotation is usually a limit switch problem, which is unfortunately
inside the rotor on those. check that you are putting out both polarities
of voltage to the motor in case there is something wrong with the relays in
the control box. Then see if you can measure resistance through the motor,
most likely you will read it like a diode which shows that one limit switch
is stuck open.
David Robbins K1TTT
e-mail: mailto:k1ttt@arrl.net
web: http://www.k1ttt.net
AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
> -----Original Message-----
> From: towertalk-bounces@contesting.com [mailto:towertalk-
> bounces@contesting.com] On Behalf Of Arnaldo
> Sent: Sunday, February 17, 2008 10:07
> To: TowerTalk@contesting.com
> Cc: pak03107@mweb.co.za
> Subject: [TowerTalk] Re Yaesu G-2800 DXC
>
> My rotator only turns clockwise. Anyone can tell me where to start looking
> for the fault.
>
>
> Many thanks
>
>
> Arnaldo
> ZS5ADS
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|