[Top] [All Lists]

[TowerTalk] Shunt Feed for 160 m done!

Subject: [TowerTalk] Shunt Feed for 160 m done!
From: Kim Elmore <>
Date: Sat, 01 Mar 2008 19:37:54 -0600
List-post: <">>
Apparently, my measurements were in the ballpark: I cobbled together 
an L-network that yields a match.

However, in the process I noticed that three of the four bolts that 
hold my rotator to the plate were gone. I could get two back in, but 
due to the wind couldn't get things positioned for the fourth. I'll 
choose a calm day, take some Loctite 242 with me, repair some broken 
control wires, and do it right this time.

Two steps forward, one step back...

Kim Elmore, N5OP


TowerTalk mailing list

<Prev in Thread] Current Thread [Next in Thread>
  • [TowerTalk] Shunt Feed for 160 m done!, Kim Elmore <=