Towertalk
[Top] [All Lists]

[TowerTalk] Wilson WR-1000 pot and repair

To: towertalk@contesting.com
Subject: [TowerTalk] Wilson WR-1000 pot and repair
From: <k8po@adelphia.net>
Reply-to: k8po@roadrunner.com
Date: Sun, 2 Mar 2008 17:07:56 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I have one of these and the pot or gearing to pot has gone bad.  Anyone taken 
one of these apart?  Any guidance would be appreciated.  
Rotor rotates fully and shows South at full rotation CW (looking from top). 
When moving CCW it shows South at approximately 270 degrees of actual rotor 
position.
At the 270 degree point, the resistance is below 20 ohms (500 ohm pot)

Thanks and 73, Paul 

--
k8po@roadrunner.com

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>
  • [TowerTalk] Wilson WR-1000 pot and repair, k8po <=