Towertalk
[Top] [All Lists]

Re: [TowerTalk] 30m/40m Yagi Ideas?

To: towertalk@contesting.com
Subject: Re: [TowerTalk] 30m/40m Yagi Ideas?
From: "larryjspammenot@teleport.com" <larryj@teleport.com>
Reply-to: "larryjspammenot@teleport.com" <larryj@teleport.com>
Date: Wed, 12 Mar 2008 12:23:16 -0700 (GMT-07:00)
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Who makes the 131 foot crankup tower that's capable of supporting multiple big 
antennas like those two? I'd like to have one, too...



-----Original Message-----
>From: Dan Hearn <dhearn@air-pipe.com>
>Sent: Mar 12, 2008 12:06 PM
>To: T talk <towertalk@contesting.com>
>Subject: [TowerTalk] 30m/40m Yagi Ideas?
>
>I am in the process of building a 2 element 2 band yagi for 30/40m. It will
>use some 20m elements, which I have, extended to full size on 30m. The
>elements will be coil loaded for 40m and the coils will be shorted with vac
>relays, which I have a good supply of, on 30m. Matching will be done using a
>50/25 ohm balun/xfmr as available from DX engineering. My thought is to use
>coils at the center of each element but I realize the 40m efficiency would
>probably be greater if the coils were further out on the elements, probably
>at the junction between the 17 ft tips and the center tubing section.
>  I plan to mount this antenna on the 2 7/8 mast above my 6 el 20m yagi.
>Spacing will probably be 10-12 ft. Height will probably be 142 ft on my 131
>ft crankup.
>  I would appreciate any comments on this proposed design. I realize that a
>lot of my questions can be answered by modeling the design but I have no
>experience in that area. I am using the Taper program to come up with the
>element lengths and would rather spend my time building the antenna and
>putting it up, Hi. I will ultimately ask for help in determining the
>inductance values for element loading.
>1. Would putting the coils out on the elements vs. at the center improve the
>gain enough to be worth the extra effort?
>2. What would be a good compromize element spacing on the boom?
>3. What do you think of using the 2:1 xfmr for matching? Seems to work for
>SteppIR.
>4. Is there any place I can buy large type 31 ferrite cores, as used in
>K9YC's great balun designs on his web page, in small quanties? I might wind
>the 2:1 balun xfmr myself.
>
>Thanks, Dan, N5AR
>
>
>
>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>