Hi,
I'm going through the same thing right now, but since my traps are
suspect, I hesitate to post their values.
As I repair them, I'm going to be setting them to these values with a
Network Analyzer:
TV1 10m 28 mHz
12m 24
TV2 15m 21.2
TV3 17m 18.11
TV4 20m 14.47
TV5 30m 10.25
This is supposed to be their initial values from what I could find on the Web.
Once I get them set, I can measure the actual value of the caps and
coils and post them if you like. I wasn't going to measure them since
I'm just looking to mechanically force them to resonance while
watching the Network Analyzer display, but if you need the values I
will measure them before I re-assemble the antenna.
Jeff/KD4RBG
---- Original message ----
>Date: Mon, 17 Mar 2008 13:18:04 -0400
>From: "Marc Tessier - VE3TES" <ve3tes@cogeco.ca>
>Subject: [TowerTalk] R7 Trap Measurements required
>To: <towertalk@contesting.com>
>
>Hello, It would appear that an easier way of doing things was to post
a link to the picture I drew up showing the required measurements, and
I have done just that, here is the link to the picture I drew up
showing exactly what measurements I need...
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|