I should have been more specific.. The new tube never even makes it to the
rivet holes. It doesn't go in at all. Not even 1/16".
Larry K5RK
> ______________________________________________
> From: Larry Burke [mailto:wi5a@sbcglobal.net]
> Sent: Friday, March 21, 2008 4:45 PM
> To: 'towertalk@contesting.com'
> Subject: Aluminum Tubing
>
>
> I ordered replacement element tips for a current production Force 12 Yagi.
> They appear to be the same size as the old ones, but they do not go into
> the mating part of the element without pounding. Since I want to be able
> to adjust and remove these at some point is there a trick for getting them
> to slide in without resorting to heating or slicing the larger tubing?
>
> I have tried the obvious -- calling Force 12 -- but they are either closed
> for Good Friday or are not answering the phone.
>
> Larry K5RK
>
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|