DENNIS BRICKEY wrote:
> Does anyone have a drilling template for an HDR-300? I'd sure appreciate the
> help! Thanks,
>
>
Place rotator upside down and anchor in place (Vise?), Take the
cardboard backing off a paper tablet and place over the bottom of the
rotator. *Lightly* tap (don't want to destroy the threads) with a
ballpeen hammer around the edges of the bolt holes being careful not to
move the cardboard. It might take a couple for practice but done
properly it will cleanly cut holes that line up with the bolt holes in
the rotator base and make an excellent, temporary template. It's also
a good way to make gaskets. Don't forget "top and bottom" of the template.
73 and good luck,
Roger (K8RI)
> Dennis N4DD
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|