Scott, I've replaced that part on a couple of Hygain rotors, including the
T2X. There's not an abundance of wire, but enough to do the job with no
problem.
73 Bill
----- Original Message -----
From: "Scott Robbins" <w4pa@yahoo.com>
To: <towertalk@contesting.com>
Sent: Saturday, May 03, 2008 11:44 AM
Subject: [TowerTalk] How about a little T2X rehab help?
> I've got a T2X recently acquired used that has a terminal strip on the
bottom
> badly corroded from exposure, to the point where 4 of the 8 screws are
rusted
> frozen solid and will not budge despite WD-40, screwdrivers, and a lot of
> begging on my part :-)
>
> Assuming I can get the screws on each side of the terminal strip loose
(which I
> have not tried yet), is there enough slack with internal wiring to take
those
> screws out, pull the terminal strip up and out without actually going in
and
> opening up the housing of the rotator? Or am I going to have to pull it
open?
> I can't really tell from looking at the pics in the manual. In any case,
this
> part is going to definitely need replacing...
>
> Thanks in advance,
>
> Scott W4PA
>
>
>
>
____________________________________________________________________________
________
> Be a better friend, newshound, and
> know-it-all with Yahoo! Mobile. Try it now.
http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|