Serving tool is simply a narrow plate with a small hole about 2 inches from
one end. I have seen them with two little fingers at the same end that are
used to kind of guide the tool around the guy wire. Ed W3AU showed me how
to make the tool with out the fingers just the little hole and it works
great. Too easy to make so I guess they stopped marketing them. Just my 2
cents worth.
73 Pete n4kw
----- Original Message -----
From: <K7LXC@aol.com>
To: <towertalk@contesting.com>; <rtnmi@sbcglobal.net>
Sent: Friday, July 11, 2008 12:08 AM
Subject: Re: [TowerTalk] Serving Tool for guy wire
>
> In a message dated 7/10/2008 6:04:00 P.M. Pacific Daylight Time,
> towertalk-request@contesting.com writes:
>
>> In reading the ROHN cat it talks about a serving tool used to wrap the
> guy wire back onto itself and around and around as a part of
> installing the guy wire. I can not seem to find a 'serving tool' for this
> purpose anywhere on the internet does anyone know where to find one?
>
> Don't believe everything you read - hi. No one has done that since
> PreForms hit the market.
>
> Cheers,
> Steve K7LXC
> TOWER TECH
>
>
>
>
>
>
>
> **************Get the scoop on last night's hottest shows and the live
> music
> scene in your area - Check out TourTracker.com!
> (http://www.tourtracker.com?NCID=aolmus00050000000112)
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|