I found this place which might be a good source for materials
http://www.speedymetals.com/pc-4435-8370-34-sch-40-pipe-6061-t6-aluminum-extruded.aspx
----- Original Message -----
From: "Richards" <jruing@ameritech.net>
To: "Peter Voelpel" <df3kv@t-online.de>
Cc: <towertalk@contesting.com>
Sent: Sunday, 27 July, 2008 10:30 AM
Subject: Re: [TowerTalk] 40m OWA
> Why not get a specifications / instructions on the original design.
> It will have the measurements and parts descriptions you need.
>
> After you get the design down, spacing etc., I think
> DX Engineering and Penninger Radio both have parts that are
> nicely made and work well for making alum antennas.
>
> www.DXEngineering.com
> www.penningerradio.com
>
> That is where I would start.
>
> ============= K8JHR ============
>
> Peter Voelpel wrote:
>
>> Is there anywhere around with a good design on a 48 foot boom which seems
>> to
>> be proven length for that beam?
>
>
> ===================================================
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|