Call Portland Bolt http://www.portlandbolt.com/ and they ship what ever
you want and like all these outfits they make them and either in house Galv.
them or send out . Also go to http://www.thomasnet.com/ and search under
Bolts and Nuts. I used a outfit in the Bronx that sells only commercial
outfits for all the bolts and anchors for my Rohn SSMW and we spent around
$500.00 on the whole order. The anchor were by them selves 4 feet long and 1
inch with nuts were $220.00 and there were 12 of them. they took a week for
them to be made and Galv.
----- Original Message -----
From: "Mark Robinson" <markrob@mindspring.com>
To: <towertalk@contesting.com>
Sent: Sunday, September 21, 2008 7:33 PM
Subject: [TowerTalk] US Tower Anchor Bolts
>I am getting ready to install the base for a US Towers HDX-589MDPL crank up
> tower. I know that US Tower supplies ungalvanized 1 1/8 OD by 27 inch
> straight anchor bolts. I think that there was a thread a while back about
> using galvanized anchor bolts with a J bend at the embedded end. Does
> anyone
> know of a source of such anchor bolts.
>
>
> 73 Mark N1UK
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|