Towertalk
[Top] [All Lists]

Re: [TowerTalk] HAM IV Question

To: <TOWERTALK@contesting.com>
Subject: Re: [TowerTalk] HAM IV Question
From: "Mike" <noddy1211@sbcglobal.net>
Date: Fri, 5 Dec 2008 19:44:14 -0800
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I lost a few ball bearings under similar circumstances and managed to buy
replacements at the Orchard Supply store believe it or not, which saved my
Sunday.

Mike, K6BR

-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of 
> Larry K3VX
It's not too difficult, but it is tedious. When you open  it, do it in or 
in/over a box or tub, else you'll be chasing ball bearings  til the code 
requirement comes back.
73,
Mike  NF4L
_______________________________________________
 
That reminds me of the time I opened up a HamM rotor on top of a roof (back

in the early 70s), not knowing what was inside.  I soon found out....about
a 
hundred or so greasy bearings that rolled down the tile roof in a clatter
and  
off into the tall grass, never to be found.  All other rotors have been  
opened up on the bench since then!
 
Bill KH7XS/K4XS
**************Make your life easier with all your friends, email, and 
favorite sites in one place.  Try it now. 
(http://www.aol.com/?optin=new-dp&icid=aolcom40vanity&ncid=emlcntaolcom00000
010)
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
No virus found in this incoming message.
Checked by AVG - http://www.avg.com 
Version: 8.0.176 / Virus Database: 270.9.14/1832 - Release Date: 12/5/2008
9:57 AM

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>