Nope... page 15 (the scematic) doesn't show the switch... nor does the shot
of the rear panel.(fig 12). This is not the calibrate pot on the front, but
the NOR/CAL switch on the reear panel.
Don B.
----- Original Message -----
From: "Jim Hargrave" <w5ifp@gvtc.com>
To: "Tower" <towertalk@contesting.com>
Sent: Tuesday, December 09, 2008 12:12 PM
Subject: [TowerTalk] FW: Hy-Gain Rotor Box Schematic
>
>
>
> Dick,
>
> Its shown in the HyGain manual. Its available in PDF form from the HyGain
> web site.
>
> http://www.hy-gain.com/man/pdf/HAM-IV.pdf
>
>
> * 73's Jim W5IFP *
>
>
> >-----Original Message-----
> >From: towertalk-bounces@contesting.com
> >[mailto:towertalk-bounces@contesting.com]On Behalf Of RICHARD SOLOMON
> >Sent: Tuesday, December 09, 2008 7:43 PM
> >To: TowerTalk
> >Subject: [TowerTalk] Hy-Gain Rotor Box Schematic
> >
> >
> >
> >Is there a reason why the HAM-IV Manual I downloaded
> >from the MFJ site does not show the Calibrate Switch on
> >the schematic ??
> >It seems a simple enough thing to show, it has been part
> >of the Control Box for eons !!
> >Very discouraging ....
> >
> >73, Dick, W1KSZ
> >_______________________________________________
> >
> >
> >
> >_______________________________________________
> >TowerTalk mailing list
> >TowerTalk@contesting.com
> >http://lists.contesting.com/mailman/listinfo/towertalk
> >No virus found in this incoming message.
> >Checked by AVG - http://www.avg.com
> >Version: 8.0.176 / Virus Database: 270.9.15/1839 - Release
> >Date: 12/9/2008 9:59 AM
> >
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|