Hi Terry,
I made the conversion on my TX-455 tower last year and it has proved to
be a good thing. Much easier to crank the tower up and down, and I also
now can use a 1/2 inch drill to do the hard work. I purchased my K2550
from Grainger, but there are other sources:
http://tinyurl.com/6osn9l*
*
Good luck with your project!
73
--
Joe Hannigan - WDØM
Pagosa Springs, CO
http://www.WD0M.com
http://www.pagosarocks.com
http://www.quiltqueen.net
Terrence R. Redding Ph.D. wrote:
> Last year I replaced the Fulton K1550 winch, after the handle broke off.
> This year I think I will replace the other winch, this time with a K2550
> model and re-cable the tower.
>
> What is the best source for the new winch and cable? Should I just order
> from Tri-Ex or is there a better faster choice?
>
> If possible I would like to do the work this week while the tower is down
> being fitted with a new Christmas star.
>
> All help greatly appreciated.
>
> Terry - W6LMJ
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|