Towertalk
[Top] [All Lists]

Re: [TowerTalk] Thrust bearing versus rotator pin bolt

To: <towertalk@contesting.com>
Subject: Re: [TowerTalk] Thrust bearing versus rotator pin bolt
From: "Mike" <noddy1211@sbcglobal.net>
Date: Wed, 6 May 2009 18:15:29 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Pin the Mast, ask my friend K6MCL across town about not following the
instructions :-)

Actually I was the guy that really suffered as I had to climb up the tower
and hang of the side and use a transfer punch to mark the holes and then
drill in a hole from each side, not fun.  Better to do the job on the
ground, those Aluminum Clam Shells cannot be tightened enough to hold the
mast reliably.

I don't understand really understand the rest of questions, I have a thrust
bearing and do not see how it relates to the mast turning in the Clam
Shells.


Mike, K6BR 

-----Original Message-----


Hi all,

My Yaesu rotator (DXA1000) specifies that the mast be pinned 50mm 
above the base.  I am also using a yaesu GS-65 thrust bearing.  The 
retaining plates that they have with this rotor are very nice, by the way.

If I pin the mast using the supplied bolt per instructions, there is 
precious little slack in the 9mm hole which allows the weight of the 
mast to be taken off the rotator-none that I can tell in fact.  Does 
the use of the pin bolt mean that the antenna/mast weight has to be 
carried by the rotator and not by the thrust bearing?

Do you think it would be a good idea to drill a larger hole in the 
mast so that there is noticeable room to pull the mast up off the pin 
as I tighten the thrust bearing bolts?  Or should I follow the 
rotator installation instructions, figuring that is how it is 
engineered?  My understanding is that having the weight of the mast 
and antenna (TA53M with 40M add-on 65lbs) would be better for the rotator.

Tom
K8TOM

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
No virus found in this incoming message.
Checked by AVG - www.avg.com 
Version: 8.5.325 / Virus Database: 270.12.19/2099 - Release Date: 05/06/09
06:04:00


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>