The spacer washers that come with the rotator are about 3/16" thick -
thicker than a
normal flat washer. I don't think it matters so much for the mast bracket.
It does matter
if you put the rotator on a rotator shelf as a single normal washer will
have the bottom
outside edge of the rotator dragging on the shelf .
73, Larry W6NWS
----- Original Message -----
From: "Jim Rhodes K0XU" <k0xu@longlines.com>
To: "John Geiger" <aa5jg@yahoo.com>; <towertalk@contesting.com>
Sent: Sunday, October 04, 2009 4:43 PM
Subject: Re: [TowerTalk] TR44 mast bracket
> The manual for the CD-45 which is about the same physically says
> 1/4"-20 x 1&1/4". They say to use the same size with a spacer when
> mounting to a shelf.
>
> At 01:54 PM 10/4/2009, John Geiger wrote:
>>I recently picked up a TR44 rotor with the lower mast
>>bracket. However, it did not come with the hex bolts to attach the
>>mast bracket to the rotor. Does anyone know what size bolts are needed?
>>
>>73s John AA5JG
>>
>
> Jim Rhodes
> jim@rhodesend.net
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|