My feed-through panel has double-female barrel connectors for coax,
ceramic feedthroughs for open wire and grommetted holes for
rotor/control cables.
This panel replaces one of the 'vent' panels in the foundation of my
home and is connected to my SPG which is located less than 6" from it.
Don
N8DE
Quoting John Hensley <w5jv@hotmail.com>:
>
> Before I reinvent another wheel :-) , can anyone send me a picture
> or two of how you did your outside to inside antenna panel? My
> ideais to put an external service box on the outside of the workshop
> withtwo or three 2" nipples passing through to an inside box. The
> outsidebox could hold a couple of small auto-wire tuners & baluns
> and theinside box could accommodate a small patch panel, extra
> ground connection,etc.
> If you don't have any pictures, perhaps a short description of what
> youfound worked best for you. I do not want to do window or eave
> passthroughs.
> TIA< John, W5JV
> _________________________________________________________________
> Your E-mail and More On-the-Go. Get Windows Live Hotmail Free.
> http://clk.atdmt.com/GBL/go/171222985/direct/01/
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|