I am proposing to use a Polyphaser type RGT suppressor in the antenna feed for
my 900MHz link. The specs appear to show that the suppressor is quite suitable
for the application - I need DC passthrough as there is an amplifier near the
antenna.
I can't find anywhere on the Polyphaser site which end should be connected
where and it is not marked on the device. One end has a bulkhead N connector
for mounting through a panel, the other a straight N connector. I am inclined
to think that it doesn't much matter - I presume the device is symmetrical. It
would be mechanically easier for me to mount the bulkhead end away from the
antenna.
If anybody knows better I would be grateful for the advice.
73 Roger
VE3ZI
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|