John--
I have one, in use. I can measure it, but not 'til tomorrow, I have a short
trip that will take most of the day. (short trips always do).
If my memory serves me, only cursory leveling is needed; the nuts let you
fine-tune it.
Bill-W4BSG
----- Original Message -----
From: "John Hensley" <w5jv@hotmail.com>
To: <towertalk@contesting.com>
Sent: Monday, November 23, 2009 2:21 PM
Subject: [TowerTalk] Need bolt hole pattern for Rohn BPH-25G
>
> The Rohn hinged baseplate for Rohn 25G is item number BPH-25G.
>
>
>
> It is held onto the base by four 1/2" x 12" J-bolts but none of the
>
> drawings spell out the bolt pattern layout dimension. Since the base
>
> plate is 15" square, I am guessing the holes are on 1" x 1" centers
>
> or 13" from hole to hole. Is this correct?
>
>
>
> My thought is to take a plywood square, drill the pattern, mount the
>
> J-bolts and then when the concrete is ready, wiggle the plywood jig
>
> in place and level it. When it dries I remove the plywood and the
>
> base is ready to go in. Should work unless I have the bolt spacing
>
> wrong. Does anyone know?
>
>
>
> John
>
> _________________________________________________________________
> Windows 7: I wanted simpler, now it's simpler. I'm a rock star.
> http://www.microsoft.com/Windows/windows-7/default.aspx?h=myidea?ocid=PID24727::T:WLMTAGL:ON:WL:en-US:WWL_WIN_myidea:112009
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|