[TowerTalk] Rohn 65G bolt flange plate question

["Clay W7CE" <w7ce@curtiss.net>]

I have Rohn 65G sections that I plan to put up and have a question about the 
bolt flange plates.  Someone told me (K0XG I think) that there are two 
versions of Rohn 65G and the flange plates (and corresponding bolt hole 
locations) are oriented differently on the two versions.  Does anyone here 
know for sure if this is true or not?  I have a lead on a used custom thrust 
bearing top plate but don't want to find out after the fact that the holes 
are drilled wrong.

Thanks,
Clay W7CE 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk