And might facilitate mounting the top tower 'outside' of the base tower,
which would look weird but make assembly and disassembly much easier.
-Steve K8LX
Bill Aycock wrote:
> I have two sub-set questions---
> 1. It sounds like the larger, base tower already exists. If so, is the
> erection process going to be 'Top-down' rather than 'base-up'?
> 2. Maybe silly--but-- have you considered looking at the systems used in
> modern, looping, Steel Roller-coasters? They work well in almost all
> directions.
> Bill--W4BSG
>
> ----- Original Message -----
> From: "jimlux" <jimlux@earthlink.net>
> To: "Tower and HF antenna construction topics." <towertalk@contesting.com>
> Sent: Sunday, March 28, 2010 12:55 AM
> Subject: Re: [TowerTalk] Homebrew Crank-up
>
>
>> Stan Stockton wrote:
>>> As mentioned the lower section would be large (33 inch face) tower
>>> with 3 inch diameter legs. The top would either be 55G or 65G. I'm
>>> interested in ideas for rollers, etc. Not worried about whether it
>>> will stay up or not. There would be guy wires on lower section.
>>>
>>> Stan, K5GO
>>>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
--
Steve Maki
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|