Thanks
----- Original Message -----
From: "Roger (K8RI)" <K8RI-on-TowerTalk@tm.net>
To: "Tower and HF antenna construction topics." <towertalk@contesting.com>
Sent: Saturday, April 10, 2010 4:38 PM
Subject: Re: [TowerTalk] Tailtwister Rotor Rehab Question
>
>
> WA3GIN wrote:
>> Hi folks,
>>
>> Rebuilding the old Tailtwister. Ballbearing look good but the grease is
>> hard and useless, not protecting the bearing much. I used 3&1 oil to
>> clean the bearings and races but wonder if I should just leave the 3&1 or
>> slather the bearing with white lithium grease.
>>
> That's what I'd use. Others say different, but I'll bet you find the
> blue grease Norn's uses is similar.
> Also, there's something wrong if a rotator is picking up particles out
> of the air.
>
> 73
>
> Roger
>> Recommendations welcome. Please respond direct.
>>
>> 73,
>> dave
>> wa3gin
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|