Towertalk
[Top] [All Lists]

Re: [TowerTalk] cutting galvanized tower legs

To: towertalk@contesting.com
Subject: Re: [TowerTalk] cutting galvanized tower legs
From: Dan H <n5ar@air-pipe.com>
Date: Sat, 31 Jul 2010 17:01:04 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
On 7/31/2010 4:40 PM, Gary Slagel wrote:
> Hi guys,
>   
> My triex w51 crankup folded over in a windstorm the other day.  I'm going to 
> have to do some cutting on it to get it all the way down and apart.  
>   
> What is the best way to cut this stuff?  Is there a metal cutting blade I can 
> put in a circular say?  Some kind of metal cutting disk I can use with my 
> handheld disk grinder/sander? 
>   
> Thanks for advice. 
>
> Gary Slagel/N0SXX
> Hot Springs, SD
> http://marina.fortunecity.com/sanpedro/351
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
>    
A small right angle grinder with a thin abrasive blade will make short 
work of the job. Mine is a Makita.

73, Dan, N5AR
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>