Towertalk
[Top] [All Lists]

Re: [TowerTalk] [FCG] Need sources of rope and fiberglass

To: towertalk@contesting.com
Subject: Re: [TowerTalk] [FCG] Need sources of rope and fiberglass
From: "Roger (K8RI)" <K8RI-on-TowerTalk@tm.net>
Date: Thu, 05 Aug 2010 15:06:35 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>

On 8/4/2010 4:08 PM, Robert & Charlotte Higgins wrote:
> Charly
>
> Check out Radio Works
>
> 73
> Bob K4LW
>
> http://www.radioworks.com/
>    
Too bad they don't offer the 3/16" Dacron in 1000' spools.

73

Roger (K8RI)
>> Hope someone can refer me to a source for
>>
>> ---very light weight, very strong (500 lbs. pull), non absorbent, sun
>> resistant line/string/rope to use to internally guy a two element quad.
>>
>> -- light weight 8 foot fiberglass rod or tube, at least 1 and half inch
>> diameter.
>>
>>
>> Well, my quad broke today in a gale.  The wind estimater says speed was 50
>> to 56 mph based on small tree blown over, twigs and limbs down, and so on.
>> I am impressed that the grass in the lots beside and behind me ... grass
>> about 2 ft tall, was blown completely flat, so he wind at actual ground
>> level was bad, too.  Standard factory Cubex with factory stiffner... 2 el
>> full size 40m, 2el on 30, and 3 el on other two WARC bands.  Really worked
>> nice!
>>
>> I made the mistake of not heading my quad West where the wind always comes
>> from... I think because it hit it on an angle, one of the top two
>> spreaders broke at about the half way point and all the wires of the
>> driven element are drooping over the mess that is left.  The reflector,
>> lacking he added load of the driven coax attached, survived.  I think the
>> driven array also rotated on the boom and the whole thing could have been
>> pushed back on the mast, it appears.
>>
>> I had plans already of putting in 8ft extensions on the ends of the boom
>> and tying the whole thing into a fully guyed internally.  I do not know
>> how I can get another fiberglass spreader shipped here, it is very long,
>> and I have only one fiberglass extension rod to do the strengthening so
>> that is another part to find.
>>
>> If you have suggestions on a very light very strong, sun resistant, non
>> absorbing string, line, rope.... please let me know.  de HS0ZCW
>>
>> Charly
>>
>>
>> _______________________________________________
>> FCG mailing list
>> Send mail - FCG@kkn.net
>> Change/edit subscription info - http://www.kkn.net/mailman/listinfo/fcg
>> FCG Web site - www.floridacontestgroup.org
>> Member Map - http://www.frappr.com/floridacontestgroup/map
>> Facebook - http://tinyurl.com/adsa9m
>> DXCluster - telnet to k4fcg.dyndns.org
>>      
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>    
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>