Mine are in water proof boxes.
Alan K9MBQ
-----Original Message-----
>From: Fred Serota <fserota@msn.com>
>Sent: Sep 1, 2010 3:11 PM
>To: towertalk@contesting.com
>Subject: Re: [TowerTalk] Protecting Screws on lightening protectors; Use for
>wire brushes on top of towers?
>
>two quick questions:
>
>1. Most of the lightening protectors for rotor controls and the SteppIR
>control lines involve exposed screw heads (albeit stainless) and bare lugs.
>Are folks spraying these connections to protect them over time? If so what
>are you using?
>
>2. Is there any benefit in protection against atmospheric charges in using
>the steel brushes that are sold for these purposes? What literature I have
>found has been equivocal on this.
>
>Fred, K3BHX
>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|