Towertalk
[Top] [All Lists]

Re: [TowerTalk] Divining rods and pyramids

To: "David J. Sourdis - HK1A" <hk1kxa@hotmail.com>
Subject: Re: [TowerTalk] Divining rods and pyramids
From: van wd8aam <vlincoln@frontiernet.net>
Date: Thu, 02 Sep 2010 00:07:28 +0000
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Gee, I just had a thought that might bring this back
onto topic.

Try Divining/dowsing over a non-working piece of ham gear, maybe
it might work to find the bad part(s)....I'm serious, and until
someone who has success with dowsing tries this, how we we know
if it does or doesn't! It'll have to be tried both turned off,
and then energized with power.

(since it seems to work depending on what
the person is looking for, maybe it just
might point out the defective part.  If it
does, would THAT be a breakthru!)

wd8aam
van


At 23:33 9/1/2010, you wrote:


>Dave, Just try it, no kidding.
>73
>
>David
>HK1A
>EC5KXA
>ex-HK1KXA
>
>
>
>
> > Date: Wed, 1 Sep 2010 12:32:34 -0700
> > From: xdavid@cis-broadband.com
> > To: towertalk@contesting.com
> > Subject: Re: [TowerTalk] Divining rods and pyramids
> >
> >
> > Either that is the most hilariously sarcastic post I have seen in quite
> > a while (if so, kudos to you), or it is now apparent that I have been
> > mysteriously transported to some weird alternative universe ....
> > possibly Narnia or some place similar to it.   Anyone out there know how
> > I can find the door in the back of the closet to get back home?
> >
> > Dave   AB7E
> >
> >
> > On 9/1/2010 9:15 AM, David J. Sourdis - HK1A wrote:
> > > I did two "L"  out of an old coat hanger wire. About 6" for the 
> handles and 30" for long part of the wire L.
> > > Take one on each hand as  an inverted L , being the vertical 
> part of the inverted L, the 6" handles, the long parts of the Ls 
> should be horizontal, parallel and looking in the same direction 
> you are walking on. When there is an underground discontinuity made 
> of water the Ls will tend to rotate to the center, making the 30 
> inch sides cross each other. Even if you rotate your wrists to the 
> outside (right wrist going clockwise, opposite for left), making 
> the rods to move upwards on an inclined plane, the rods will rotate 
> to the center overcoming the pull of gravity for small 
> inclinations. I could locate the positions of the corners of an old 
> sewer system well in my backyard with this rods. Not a good place 
> to put a tower, hihi
> > > More interestingly: I did the rods from a book about Pyramids 
> ("The magical powers of the pyramid" is the translation of the 
> spanish title). Using thin cardboard, I made a scaled version of 
> the Gizah pyramids, about three inches high and a second one about 
> three times that size.
> > > When the rods where moved at belly height over one of the 
> pyramids sitting on the floor, the rods would rotate to the center 
> very quick, ONLY IF the faces of the pyramid were aligned with the 
> cardinal points the rods would move, if the faces were aligned with 
> NE, SE, NW and SW, instead of N, S, E, W, the rods wouldn't move.
> > > To make the pyramid: Draw a circle on the cardboard. The radius 
> of the circle multiplied by 1,0517 (the radius + 5.17%) is the 
> square base's side lenght. With the base lenght draw four end to 
> end chords on the circle and then draw lines between the ends of 
> the chords and the circle center, this lines will be the edges of 
> the pyramid that part from the square base corners and meet at the 
> top (circle center). The chords are the four bottom sides of the 
> faces. The four resulting triangles are the faces of your pyramid, 
> no base needed. Then cut out the drawing and bend by the edges to 
> form the pyramid, it is wise to leave an extra flip strip on one of 
> the end faces to make the closing and gluing of the pyramid easier 
> and stronger.
> > > CHORD:http://en.wikipedia.org/wiki/Secant_line
> > > Sorry about Pyramid talk, back to Tower Talk :o)
> > > 73
> > >
> > >
> > > David
> > > HK1A
> > > EC5KXA
> > > ex-HK1KXA
> > >
> > _______________________________________________
> >
> >
> >
> > _______________________________________________
> > TowerTalk mailing list
> > TowerTalk@contesting.com
> > http://lists.contesting.com/mailman/listinfo/towertalk
>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>