Please help with a little more info, and we may be able to identify it.
1. Is the shield aluminum or copper?
2. Is the shield smooth or ridged.
3. If ridged is the shield like a series of smaller and larger diameters,
or is the ridge a spiral?
73,
Joe kk0sd
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Robert Chudek - K0RC
Sent: Tuesday, November 02, 2010 9:37 PM
To: guy_molinari@hotmail.com; TowerTalk@contesting.com
Subject: Re: [TowerTalk] Mystery hardline
Guy,
No, I don't have a clue what it might be. It's kind of like asking "I've got
a set of four black tires with white sidewalls on one side of them. Will
they work on my car?"
But you can test the coax and get a rough idea about the impedance by
putting a 50 ~ 52 Ohm resister at the far end and measuring the VSWR. If
it's 1:1 that would tell you it's a 50 Ohm impedance. If it's 1.5:1 that
would suggest a 75 Ohm impedance. Or you could put a 100 Ohm potentiometer
at the far end and adjust it for minimum VSWR, remove the pot, and measure
its resistance. That will be the approximate impedance of the cable.
If you have (or can borrow) an antenna analyzer (MFJ259), you can short the
far end and measure the lowest frequency of the VSWR dip. Then you can
calculate the velocity factor by measuring the physical length compared to
the free-space (calculated) length. This will give you the ratio between the
two (i.e., the velocity factor).
With a couple basic tools, you should be able to determine what you need to
know. It's a good problem to have that will teach you about RF and some
basic measurements. You can Google "measuring unknown cable impedance" and
find more specific details.
73 de Bob - KØRC in MN
Message: 4
Date: Tue, 2 Nov 2010 06:15:28 +0000
From: Guy Molinari<guy_molinari@hotmail.com>
Subject: [TowerTalk] Mystery hardline
To:<towertalk@contesting.com>
Message-ID:<BAY129-W16905245A9B5BD0978CBAE8490@phx.gbl>
Content-Type: text/plain; charset="iso-8859-1"
I picked up some surplus hardline. It has an OD of 5/8" including a 1/16"
plastic jacket. The jacket is black and has a green stipe running up 2
sides of the cable.
Any idea of what this stuff is? Specs?
73,
Guy, N7ZG
------------------------------
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|