Rroger (K8RI on TowerTalk) schreef:
>>> Michael de W5NIG
>>>
>> We (PI4CC) has bas experience with this rotor. Within 5 years it hits
>> the trash can.
>>
> Hopefully not. They use normally available automotive parts except for
> the gears them selves. The bearings and seals are inexpensive automotive
> parts. Although fairly easy to rebuild there are a few critical points
> which are addressed in the rebuilding link above. It cost me less than
> $30 for all new seals and bearings. The top and bottom of which are
> very common wheel bearings.
>
> 73
>
Roger
There was no way to to get the bearings of the as.
We have used pulley's, heating, but is was so heavy rotten together
there there was no other solution to trash it
peter
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|