I am using a NN4ZZ tilt plate with my MonstIR. Also have the locking plate
for the tilt plate.
The only negative I have found is that when titling over the tower (80' Rohn
45) the antenna is not completely level. The far side comes down first,
about 15-20 degrees off of level so I use a stepladder on the end of the
40-M driver to help level it so I don't need two people to drop the tower.
73,
N2TK, Tony
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Richard (Rick)
Karlquist
Sent: Sunday, May 08, 2011 8:29 PM
To: JWKIMBALL@aol.com
Cc: towertalk@contesting.com
Subject: Re: [TowerTalk] Monstir and tilt plate
I have a homebrew tilt plate on my MonstIR and it has never
worked right in terms of staying level. What is the problem
you are having?
Rick N6Rk
On 5/8/2011 3:09 PM, JWKIMBALL@aol.com wrote:
> Anyone out there have a Monstir installed on a NN4ZZ tilt plate. I'm
having
> trouble getting mine to work properly and need some help.
>
> Thanks
>
> Jim
> K5AUP
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|