I too would appreciate a copy,
Thanks, Dick, W1KSZ
On Tue, Jun 7, 2011 at 5:58 AM, Les Kalmus <w2lk@bk-lk.com> wrote:
> Pete,
>
> Try this page too:
> http://www.tessco.com/products/displayProducts.do?groupId=576&subgroupId=40
> <http://www.tessco.com/products/displayProducts.do?groupId=576&subgroupId=40>
> Go about 2/3 down the page.
>
> 73, Les W2LK
>
> On 6/7/2011 7:45 AM, Pete Smith wrote:
>> I bought a crimping tool at Dayton with two dies, but the openings in
>> the dies are identified only by dimensions, not by the connector they
>> are to be used on. I've tried Googling without success, but suspect
>> there must be a table somewhere that I can use for reference - any ideas?
>>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|