This antenna might have originated for a non-amateur user that needed
coverage below 7 MHz. That might be a reason the smaller tube was shoved
so far inside the larger tube. I'll probably never know for certain as
the antenna is 40+ years old.
I have a schematic/diagram of the ham version (Telrex Model 40M-BFD) and
it starts out with 1.5" center tubing. This one goes two sizes larger,
2" and 2.5". Maybe this one was a 40M-Really BFD ???
73 de Bob - K0RC in MN
------------------------------------------------------------------------
On 9/7/2011 7:19 PM, Gene Fuller wrote:
> There is no "simple " answer. IT ALL DEPENDS - on bending moments,
> restraining moments, strength of materials, loading, etc. If the
> larger dia tube is getting near it's limit you might want to extend
> the smaller tube further into the larger to accumulate restraining
> moment. With my LP 46 foot elements I have four layers of tubing near
> the boom. That way I keep the OD down to 1 5/8" but should be safe up
> 100 mph with 1/4 " of ice and a good safety factor. So far it's been
> fine up to 85 mph...............
>
> ----- Original Message ----- From: "Robert Chudek - K0RC"
> <robert.chudek@gmail.com>
> To: <TowerTalk@contesting.com>
> Sent: Wednesday, September 07, 2011 7:16 PM
> Subject: Re: [TowerTalk] Aluminum tubing slip joints seized - my final
> answer
>
>
>> The issue was a little more "complex" than I first thought.
>>
>> I discovered there wasn't a simple 4" to 6" of overlap, but about 48"
>> instead. It's apparent this antenna was not assembled to manufactures
>> specifications. The extra tubing did not add to the mechanical strength.
>> It only added unnecessary weight. The excess tubing was at the tip end
>> of the tube, not the tower end.
>>
>> What did work to some extent was inserting another (long) tube from the
>> opposite direction and driving the inside tube toward the tip. This was
>> only partially successful and I had to resort to the hacksaw. Actually,
>> I used a tubing cutter for a clean cut. Then I drove the remaining
>> inside piece back toward the tower end. I had to use this method on both
>> halves.
>>
>> Pulling a few pieces from my aluminum pile I was able to reassemble the
>> antenna. At the same time I added stiffening to the junctions by adding
>> internal sleeves where needed.
>>
>> The remaining task is to model this (again) and see how to make a 62.5
>> foot element resonate at 7.1 MHz. I'm thinking capacity hats somewhere
>> out near the ends, like the Cushcraft 2 element 40m yagi.
>>
>> 73 de Bob - K0RC in MN
>> ------------------------------------------------------------------------
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|