On 9/28/2011 6:25 AM, Eric Rosenberg wrote:
> I'm finally putting together new feedlines for my pennants, which are fed
> with SP-259 (RF) connectors. I have Snap-N Seal RF and BNC connectors but
> don't know what to do for PL-259s. I've never used this cable before.
IIRC the same connectors fit CNT240 that fit 8X and RG6, at least the
crimp connectors do.
I've found the shield to be quite fragile on the CNT240 as well as the
center conductor if there is going to be much movement as in feeding,
center fed sloping dipoles. When cutting the jacket, just score it and
then separate it at the score line by bending the cable slightly.
73
Roger (K8RI)
>
> Suggestions and recommendations are appreciated.
>
> 73,
> Eric W3DQ
> Washington, DC
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|