On 10/19/2011 1:41 PM, Tim Duffy K3LR wrote:
> I have several coax switches that have the female UHF connectors (SO-239)
> mounted right next to each other - in a cluster of 10 or 12
> connectors/cables.
>
>
>
> This makes it hard to insure each coax cable with a male UHF connector
> (PL-259) is properly tight.
>
I put them in sequentially and make sure they are tight as I go. That's
tight as in too tight to take out just by fingers.
73
Roger (K8RI)
>
>
> Do you know of a tool that is made (maybe a Craftsmen automotive tool?) that
> would allow an extended grab of the shell of a PL-259 that would insure
> proper tight torque in a "tight" cluster of connectors?
>
>
>
> Thanks and 73,
>
> Tim K3LR
>
>
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|