Towertalk
[Top] [All Lists]

[TowerTalk] Fwd: UNUN Question

To: towertalk@contesting.com
Subject: [TowerTalk] Fwd: UNUN Question
From: HansLG@aol.com
Date: Wed, 25 Jan 2012 20:46:07 -0500 (EST)
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I don't think the capacitance is as much a problem as a possible saturation 
 or low inductance would make. The effect is, possible, a bit lower 
performance  at the low end of the frequency span.
 
Hans - N2JFS
 
 
  
____________________________________
 From: jim@audiosystemsgroup.com
To: towertalk@contesting.com
Sent:  1/25/2012 7:35:46 P.M. Eastern Standard Time
Subj: Re: [TowerTalk] UNUN  Question


On 1/25/2012 12:00 PM, RLVZ@aol.com wrote:
> I have a  W2FMI 25 to 50 ohm UNUN Transformer.  (1 to 2   ratio)
>
> Could I use this same UNUN to temporarily match 50 to  100  ohms?  (same 1
> to 2 ratio)

Yes, to the extent  that the stray C associated with that number of turns 
on that particular  core doesn't cause a problem.

73, Jim  K9YC


_______________________________________________



_______________________________________________
TowerTalk  mailing  list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>
  • [TowerTalk] Fwd: UNUN Question, HansLG <=