Yup! That works too. How did you handle the "bearing" above the rotor? Just
a short piece of pipe larger than the mast? Most folks don't have a lower
mast support for their Ham-4 or Tailtwister though.. :)
73
Jim W7RY
--------------------------------------------------
From: "Dick" <dick@ny1e.com>
Sent: Sunday, January 29, 2012 5:54 PM
To: <towertalk@contesting.com>
Subject: [TowerTalk] Swinging Gate Side Mount - Additional Turning Radius?
> I don't like the swinging gate from IIX. Here's why. The mounts only
> clamps
> to ONE leg of the tower. You have to tighten the U bolts too tight to get
> the mount not to turn. This puts way too much pressure onto the leg.
>
> I like a design that I found here:
> http://www.arraysolutions.com/Products/sidemountusersguide1.htm It Uses
> angle iron to connect to two legs of the tower. There is no possibility of
> slippage so you don't have to over tighten the U bolts.
>
> Array solutions seems to be over engineered for most antennas, My homebrew
> one is a compromise:
> http://www.ny1e.com/smount.jpg
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|
