Take a look at the Dutton-Lainson DLB2500A. I just purchased one from
Amazon.com and it was a "snap" to install in the existing holes.
On Wed, Mar 14, 2012 at 1:46 PM, Tony <dxdx@optonline.net> wrote:
> All,
>
> I called Fulton and asked if the bolt pattern on their K2550 winch was
> the same as the K1550. The tech said it was close, but not a match. I
> know that more than one member of this reflector has replaced the 1550
> with the 2550 on a U.S. Tower TX80 raising fixture without modifying
> the mounting plates on either the winch or the fixture so the only thing
> I can think of is that Fulton may have modified the bolt slots on the
> winch at one time. Any ideas?
>
> Tony
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
--
Tnx es 73
Richard W7ZR
www.w7zr.com
*Be joyful in hope, patient in affliction, faithful in prayer*
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|